New CAT Equipment
D350 GC (60 Hz) Generator Set
Get a Quote
Saves up to 33% Installed Space
Requires less space for installation; leaves more room for your on-going operations
Weighs up to 19% Less
Easier handling; less structural reinforcement required to support genset weight
Standard 105°C Alternator Temperature Rise
Meets most all specifications; ensures long alternator life
-
Engine Specifications
Aspiration
Turbocharged Air-to-Air AftercooledBore
5.1 inCompression Ratio
16.3:1Displacement
763 in³Engine Model
Cat® C13 In-line 6, 4-cycle dieselFuel System
MEUIGovernor Type
ADEM™A4Stroke
6.2 in -
Generator Set Dimensions
Dry Weight - Genset (maximum)
7255.4 lbDry Weight - Genset (minimum)
6929.1 lbHeight - Maximum
96.7 inHeight - Minimum
80.3 inLength - Maximum
182.8 inWidth - Maximum
64.2 in -
Generator Set Specifications
Duty Cycle
StandbyEmissions/Fuel Strategy
U.S. EPA Tier 3 CertifiedFrequency
60 HzSpeed
1800 rpmStandby Rating
350 ekWVoltage
480 to 600 Volts
Air Inlet System
- Air cleaner - Non canister, disposable
Control Panel
- GCCP 1.2
Cooling System
- Radiator sight gauge
- Blower fan and fan drive with guards
- Radiator, package mounted
- Coolant drain valve
- Thermostats and housing
- Jacket water pump, gear driven, centrifugal
Exhaust System
- Exhaust manifold - dry
Fuel System
- Integral tank base, 24 hours, UL142
- Engine fuel transfer pump
- Primary fuel filter w/integral water separator and secondary filter, spin on
- Fuel cooler
- Fuel priming pump
Generators and Generator Attachments
- Brushless, self-excited 2/3 pitch (600V uses Internal excitation (IE))
- IP23 Protection
- Voltage regulator (single phase sensing)
- Insulation system, Class H
Governing System
- Cat electronic governor (ADEM A4)
Lube System
- Oil drain with valve
- Lubricating oil, CK-4 (10W-30)
- Oil filter, spin on
- Oil cooler
- Oil filler and dipstick
- Fumes disposal to front of radiator
- Shallow oil pan
Mounting System
- Captive linear vibration isolators between base and engine-generator
- Includes lifting provisions and termination points for coolant and lube oil drain lines
Protection
- Safety shutoff - High water temperature
- Safety shutoff - Low oil pressure
- Safety shutoff - Overspeed
Starting/Charging System
- 24-volt electric starting motor
- 24V, 45 Amp Charging alternator
General
- Vibration damper
- Parts book
- Lifting eyes
Bases, Mounting & Fuel Tanks
- Wide Base - Skid
- Overfill prevention valve
- 5 Gallon Spill Containment
- Fuel tank pill pipe & lockable cap
- Integral tank base, 24 hours, UL142
- Audio & visual fuel alarm (@90% fuel level)
Circuit breaker
- Auxiliary contacts
- 400A LSI
Control System
- Volt free contacts
- Ground fault relay
- Audible alarm Gp
- Twist release, Red button emergency stop
- 20A GFCI (Ground Fault Circuit Interrupter)
- 100A Load center
- Product link remote monitoring hardware
- 16 -light NFPA 99/110 Annunciator
Enclosures
- E-Stop
- Sound attenuated Level 2 enclosure (White)
- AC & DC Source lights
Exhaust System
- Flexible exhaust connection
- 8" Muffler - 25 dBA attenuation
- Manifold and turbocharger guards
Generator
- Space heater
- Permanent magnet excitation (PMG) generator
Starting System
- Battery charger (UL Certified)
- Jacket water heater
- Standard battery set: 1000 CCA, 90 amp/hr.
- Oversize battery set, 1400 CCA, 200 amp/hr
Circuit breakers
- Shunt trip for IEC circuit breaker
General
- Extended Service Coverage
- UL2200 Certification
- CSA Certification
- Generator test report
starting / Charging System
- Jacket water heater
- Battery disconnect switch