-
Aftertreatment Dimensions
Length
16.1 inWeight
12.8 lb -
Aftertreatment Dimensions*
Diameter
6.1 in -
Emission Standards
Emissions
U.S. EPA & CARB Tier 4 Final, EU Stage V -
Engine Dimensions - Approximate
Height
30.2 inLength
31.7 inWeight - Net Dry - Basic Operating Engine Without Optional Attachments
509 lbWidth
20.8 in -
General
Aftertreatment
DOC+DPFAspiration
Turbocharged (T) or Turbocharged-Aftercooled (TA)Bore
3.3 inCombustion System
Direct InjectionCompression Ratio
17.0:1Displacement
135 in³Engine Configuration
In-Line 4, 4-Stroke-Cycle DieselRotation from Flywheel End
CounterclockwiseStroke
3.9 in -
Power Rating
Maximum Power
74 HPMaximum Torque
199 lb-ft @ 1600 rpmMinimum Power
60 HPRated Speed
2800 rpm
Control System
- Alternator 12 volt 85 amp
- Starter motor 12 volt
- Glow plug starting aid, delivers heat directly to cylinder for best starting performance in cold weather
- Electronic control unit - chassis mounted
- Flexible and configurable software features and well supported SAE J1939 CAN bus enables highly integrated machines
- Wiring harness connectors and sensors are waterproof and designed to withstand harsh off-highway environments
Flywheels and Flywheel Housing
- SAE No. 4 standard flywheel housing
- Choice of flywheel weight and bolting pattern to accommodate a range of industry-standard hydraulic pumps and transmissions
Fuel System
- 2000 bar high-pressure common rail system
- Proprietary fuel filters to ensure engine protection through correct service procedures, along with water-in-fuel detection, ensures maximum machine up-time for the operator
Lube System
- Alternative oil fillers
- Spin-on lube oil filter
Power Take Off (PTO)
- SAE A PTO drive
General
- Cast iron engine block
- Cast iron exhaust manifold
- Gradeability 35° continuous
- Paint: Cat yellow
Aftertreatment/Clean Emissions Control Equipment
- Diesel Oxidation Catalyst (DOC)
- Diesel Particulate Filter (DPF)